Bosch WTN8543SME, Инструкция по установке и эксплуатации

Страница: 13 / 40

Installation and connection
en
13
5
Installation and
connection
Installation and connection
Scope of delivery
■
Dryer
■
Installation and operating
instructions
■
Basket for woollens
*
■
Condensation drain*
Installing and connecting
the dryer
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
■
Check the dryer for visible damage.
You must not operate the dryer if it is
damaged.
■
Before connecting the dryer to the
power supply, ensure that the
electric voltage specified on the
rating plate matches the voltage of
your socket.
■
Only use earth-leakage circuit
breakers with the following symbol:
z
.
■
Ensure that the mains cable is not
kinked or trapped, and that it does
not come into contact with heat
sources or sharp edges.
:
Warning
Children may lock themselves in the
dryer, putting their lives at risk!
Do not set up the dryer behind a door
or sliding door, as this may obstruct the
dryer door or prevent it from opening.
Caution!
Risk of injury
■
Due to the heavy weight of the dryer,
you may injure yourself if you lift it.
Do not lift the dryer on your own.
■
You could cut your hands on the
sharp edges of the dryer. Do not
hold the dryer by the sharp edges.
■
Protruding parts on the dryer may
break off when it is lifted or pushed.
Do not move the dryer by holding
onto protruding parts.
Caution!
Risk of material damage to the dryer
or fabrics.
■
Check the dryer for damage caused
during transportation. Never operate
a dryer if it is damaged.
■
Any residual water in the dryer may
freeze and damage the dryer. Do not
install the dryer in rooms that are at
risk of frost.
During installation, ensure that:
■
The dryer is placed on a clean, level
and firm surface,
■
The mains plug can be accessed at
all times,
■
The air inlet on the dryer is kept clear
and there is sufficient ventilation,
■
The area around the dryer is kept
clean and
■
The dryer is levelled using the
threaded feet.
Note:
Check the alignment of the
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
Note:
If in doubt, have the appliance
connected by a specialist.
* Depending on the model