Bosch WTG86403UC, Инструкция по использованию и уходу / Руководство по установке

Страница: 33 / 40

33
Cleaning the moisture sensors
The dryer is equipped with a stainless-steel moisture
sensor. The moisture sensor measures how damp the
laundry is.
After long periods of use the moisture sensor may
become covered by a fine layer of limescale or residue
of detergents and textile care products. Such residue
must be removed regularly as the sensor function will be
impaired and the drying results less than desired.
To clean the moisture sensors:
1.
Open the door.
2.
The deposit on the sensors can easily be removed by
wiping the sensors (the two bars next to the lint filter)
with a cloth and white vinegar.
NOTICE:
Use white vinegar only!
Clean the moisture sensors once a month.
Maintenance of drain hose
If
DR
indicator lights up check the drain hose for kinks,
restrictions or blockage.
NOTICE:
If
DR
indicator still lights up after the above
steps are taken, you should contact Customer Service.
Replacing fuses in the Power Adapter -
step-by-step
Fuses are a required safety device intended to last for
the life of the product. In the unlikely event one fails
follow the below steps to replace it.
1.
Unplug the Washer and Dryer cords from the Power
Adapter.
Unplug the Power Adapter from the wall outlet.
2.
Remove fuse holder using a pointed tool as shown
(e.g. pick or small screwdriver).
3.
Replace suspected bad fuse with a known good one.
NOTICE:
USE ONLY THE REPLACEMENT FUSE,
PART NUMBER 10013781.
4.
Reinstall the fuse and fuse holder in the Power
Adapter ensuring it snaps into place.