Bosch WLG20260BY, Инструкция по эксплуатации и руководство по установке

Страница: 47 / 54

47
Before the 1st washing
The washing machine was thoroughly tested before leaving the
factory. To remove any water that may be left over from the test,
run the first wash cycle
without
any laundry.
²
The washing machine must have been installed and connected
properly. See chapter Installing from
~
Page 38
1.
Check the machine.
²
Never switch on a damaged machine. Inform customer services.
~
Page 35
2.
Connect the mains plug.
3.
Turn on the tap.
4.
Switch on the appliance.
5.
Close the door (do not load any laundry).
6.
Select the
i ü Cottons
programme.
7.
Select the temperature
90 °C
.
8.
Open the detergent drawer.
9.
Pour approx. 1 litre of water into dispenser
II
.
10.
Add standard detergent to dispenser
II
according
to manufacturer’s instructions for light soiling.
²
To prevent frothing, use only half the recommended amount of
detergent. Do not use any woollens or mild detergents.
11.
Close the detergent drawer.
12.
Select
A Start
/Reload.
13.
Switch off the appliance at the end of the programme.
Your washing machine is now ready to use.