Installation and connection
en
13
ATTENTION!
If residual water in the appliance
freezes, this may cause damage to
the appliance.
▶
Do not install or operate this appli-
ance anywhere that is liable to ex-
perience frost or outdoors.
If the appliance is tilted at an angle
greater than 40°, residual water may
leak out of the appliance and cause
material damage.
▶
Tilt the appliance carefully.
▶
Transport the appliance in an up-
right position.
Installation loca-
tion
Requirements
Base
Secure the appli-
ance with fixing
brackets
→
Wooden joist
floor
Place the appli-
ance on a water-
resistant wooden
board (minimum
thickness of
30 mm) which is
screwed tightly to
the floor.
Installation loca-
tion
Requirements
Kitchen unit
Only install the
appliance under-
neath a continu-
ous worktop that
is securely con-
nected to adja-
cent cabinets.
Required niche
width: 60 cm.
Note:
The use of
sliding plates
→
makes
it easier to slide
the appliance
into the recess.
Moisten the slid-
ing plates with a
mixture of water
and washing-up
liquid before
pushing the ap-
pliance in. Do
not use grease
or oil to do this.
Against a wall
Do not trap the
hoses and power
cord between the
wall and the ap-
pliance.
4.4 Removing the transit
bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Note:
Keep the transit bolt screws
and the sleeves in a safe place for fu-
ture transport →
Содержание WIW24307ES
Страница 55: ......