Faults and what to do about them.
en
53
Information on the display panel
Display
Cause/remedy
Pause: Reload is not
possible
Water level or temperature is too high. Press the
A
button to continue the
programme.
Door cannot be
unlocked: Water level
or temperature is too
high
Water level or temperature is too high. Press the
A
button to continue the
programme.
The door cannot be
locked; please open
the door again, then
close it and select the
A
button.
■
Laundry may be caught. Open and close the door again and press the
A
button.
■
If necessary, push the door closed or remove some laundry and then push it
closed again.
■
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
Please open tap
■
Turn on the tap fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter.
Please clean pump
■
The drain pump is blocked. Clean the drain pump.
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
AquaStop has been
activated! Please call
the after-sales
service
Does not occur for models without AquaStop
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service.
Auto power-off in ...
seconds,
Appliance automatically switches off after ... seconds if it is not operated for a
prolonged period. To cancel, press any button.
Water cooling
To protect the wastewater pipes, the hot detergent solution is cooled before being
drained.
Drum care
information:
This instruction reminds you to carry out the
Drum clean 90 °C
programme or a
60 °C programme to clean and care for the drum and the outer tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents designed for woollens or delicates.
■
Switch reminder information on/off.
Other displays
Error E:XXX
Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call the after-sales service.