49
Faults, what to do?
Faults
Cause/Remedy
Water is running out.
– Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
Water not flowing in.
–
Avvio
/Pausa (
Start
/Pause)
A
not selected?
– Tap not open?
– Filter blocked? Clean the filter.
– Supply hose kinked or jammed?
Dispenser is empty
and fill level display
is not flashing.
– Drawer cover/rear drawer plug dirty?
Cleaning
– Detergent drawer not inserted correctly? Insert correctly.
Wrong detergent/
softener has been
poured into
dispenser.
Dispensers:
1. Drain and clean dispensers.
2. Refill dispensers.
Detergent/softener
congealed in the
dispensers.
Clean and refill dispensers.
Washing machine
door cannot
be opened.
– Safety function active. Stop programme?
–
Rinse Hold
$
(without final spin) selected?
– Can be opened via emergency release only?
Programme does
not start.
–
Avvio
/Pausa (
Start
/Pause)
A
or
Fine fra (Finished in)
time
selected?
– Door closed?
– Childlock active? Deactivate.
Detergent solution is
not drained.
–
Rinse Hold
$
(without final spin) selected?
– Clean outlet pipe and/or drainage hose.
Water not visible in
the drum.
Not a fault – water below the visible area.
Spin result not
satisfactory.
Washing wet/too
damp.
– Not a fault – unbalanced load detection system has stopped the
spin cycle, washing unevenly distributed.
Distribute small and large items of washing in the drum.
–
p
Less Ironing
selected?
– Too low speed selected?
Spin cycle activated
several times.
Not a fault – unbalanced load detection system adjusts imbalance.
Residual water in the
dispenser for care
product.
– Not a fault – effect of the care product not impaired.
– If required, clean insert.
