Bosch WAXH2KL0SN, Руководство пользователя и инструкции по установке

Страница: 37 / 72

Basic operation
en
37
Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press ⁠ .
a
The drum rotates and load detection
takes place. This can take up to 2
minutes, after which water enters the
drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended, the
display shows:
End
.
Soaking laundry
You can soak the laundry before wash-
ing in the appliance by pausing the
programme.
Note:
No additional detergent is re-
quired. The soaking solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
⁠ .
3.
To resume the programme, after the
desired soaking time, press
⁠ .
Adding laundry
Note:
Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
1.
Press ⁠ .
The appliance is paused and checks
whether it is possible to add or re-
move laundry. Take note of the pro-
gramme status.
→
"Display", Page 21
2.
Add or remove laundry.
3.
Close the door.
4.
Press ⁠ .
Cancelling the programme
Once the programme has started, you
can cancel it at any time.
Note:
Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
1.
Press ⁠ .
2.
Open the door.
The appliance door remains locked
for safety reasons if the temperature
and water levels are high.
– If the temperature is high, start the
Rinse
programme.
– If the water level is high: Start the
Spin
or
Drain
programme.
3.
Remove the laundry.
Resuming the programme
when the programme status
is Rinse Hold
1.
Set the
Spin
or
Drain
programme.
2.
Press ⁠ .
Unloading the laundry
Note:
Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
1.
Open the door.
2.
Remove the laundry.