en
Before using for the first time
20
Before using for the first time
6 Before using for the
first time
Before using for the first time
Prepare the appliance for use.
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
1.
Press .
The switch-on process takes a few
seconds.
2.
Set the
Drum Clean
programme.
3.
Close the door.
4.
Pull out the detergent drawer.
5.
Add washing powder to the
manual dosing compartment.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
6.
Push in the detergent drawer.
7.
Press
(Start/Reload) to start the
programme.
a
The display shows the remaining
programme duration.
a
After the programme has ended,
the display shows:
-0-
.
8.
Start the first wash cycle or press
to switch off the appliance.
