Bosch WAX32K50NL, Руководство пользователя и инструкции по установке

Страница: 33 / 64

ServiceNL
Comments
sThe program settings will be
not stored permanently for the
program.
sWhen you use the intelligent dosing
activates or deactivates the
system, the setting is saved.
Remark:Keep the directions for
detergent and care agent →
Page 32
at.
1.
Pull out the detergent drawer.
2.
Fill with detergent.
→
"Detergent drawer", Page 19
3.
Fill with detergent if desired.
13.4 Filling the drum with
laundry
4.
Slide the detergent drawer into the
appliance.
Remark:To avoid creasing, observe the
maximum load of the programs.
→ "Programs", Page 27
13.6 Starting the program
Required:A program is set.
→ "Set program", page 32
Required:The laundry is prepared.
→ "Laundry", Page 31
▶
onStart/Refill to press.
1.
Open the door.
Make sure the drum is empty.
aThe drum rotates and a
load recognition takes place, which
can take up to 2 minutes, after
which the water flows into the
device.
aThe display shows the program
duration function ready in time. a
After the program end, it shows
display: -0-.
2.
Place the laundry in the drum.
3.
Close the door.
Make sure that no small items of
laundry are caught in the door.
13.5 Dosing detergent and care
agent
13.7 Soaking laundry
Remark:No additional detergent is
needed. The soapy water is then used
for washing.
In programs where intelligent dosing
is not possible or desired, you can
dose the detergent manually.
1.
Start the program.
2.
To pause the program, after about
10 minutes, pressStart/ Refill
.
Tip:In addition to the intelligent
dosing, you can also add other
detergents such as stain remover,
starch or bleach to the manual dosing
compartment. Do not add additional
detergent to the manual dosing
compartment to avoid overdosing or
foaming.
3.
To resume the program after the
desired soaking time, press Start/
Refill
.
33