Bosch WAX28EH1GR, Руководство пользователя и инструкции по установке

Страница: 71 / 84

Troubleshooting
en
71
Fault Cause and troubleshooting
Vibrations and move-
ment of the appliance
whilst spinning. Transit bolts have not been removed.
▶
Removing the transit bolts
Drum does not turn,
water does not flow in. Load detection is active.
▶
Not a fault – no action required.
Note:
The load detection can take up to two minutes.
Heavy foam build-up Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
▶
If intelligent dosing is activated, reduce the basic
dosage →
Page 53 .
▶
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
⁠
i-DOS
cannot be ac-
tuated.
Intelligent dosing is not intended for this programme.
▶
Not a fault – no action required.
Programme progress does not allow intelligent dos-
ing.
No remedial action possible.
High spin speed not
reached. A low spin speed is selected.
▶
The next time you run a wash cycle, set a higher
spin speed.
Easy-Iron
is activated.
▶
Select the programmes that are suitable for the
type of fabric.
→
"Programmes", Page 30
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the
Spin
programme.
The spin programme
does not start. Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.