en
Cleaning and servicing
62
5.
Insert the pump cap and screw it
on as far as it will go.
90°
The handle on the pump cap must
be in a vertical position.
6.
Insert the maintenance flap and
lock it into place.
1
2
7.
Close the maintenance flap.
18.6 Cleaning the intake
opening in the rubber
gasket
Regularly check the intake opening
in the rubber gasket for any block-
ages and clean the intake opening.
1.
Open the appliance door.
2.
Remove any blockages from the
intake opening.
Note:
Do not use any sharp or poin-
ted objects.
18.7 Cleaning the water outlet
hose at the siphon
1.
Switch off the appliance.
2.
Disconnect the appliance's mains
plug from the power supply.
3.
Loosen the hose clamp and care-
fully remove the water outlet hose.
Residual water may leak out.
