Faults and what to do about them.
en
57
Information on the display panel
Display
Cause/remedy
Re-fill the i-DOS
i
I
w
,
w
dispenser
The i-DOS dispensers are below the minimum fill level; top up
.
i-DOS
i
I
w
, i-DOS
w
error;
deactivate i-DOS
i
I
w
,
i-DOS
w
set i-DOS
i
I
w
, i-DOS
w
to
off
.
Call the after-sales service. The appliance can still be operated using manual
Please close detergent
drawer
Push the detergent drawer in correctly.
Pause: Reload is not
possible
Water level or temperature is too high. Press the
A
button to continue the
programme.
Door cannot be
unlocked: Water level or
temperature is too high
Water level or temperature is too high. Press the
A
button to continue the
programme.
The door cannot be
locked; please open the
door again, then close it
and select the
A
button
■
Laundry may be caught. Open and close the door again and press the
A
button.
■
If necessary, push the door closed or remove some laundry and then push
it closed again.
■
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
Please open tap
■
Turn on the tap fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter.
Please clean pump
■
The drain pump is blocked. Clean the drain pump.
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
AquaStop has been
activated! Please call the
after-sales service
Does not occur for models without AquaStop
There is water in the base trough; the appliance is leaking. Turn off the tap. Call
the after-sales service.
Auto power-off in ...
seconds
Appliance automatically switches off after ... seconds if it is not operated for a
prolonged period. To cancel, press any button.
Water cooling
To protect the wastewater pipes, the hot detergent solution is cooled before
being drained.