Operating the appliance
en
25
The indicator light on the programme
selector lights up and the
default
programme settings
for the selected
programme appear in the display panel.
■
Temperature
■
Spin speed
■
The maximum load and the duration
of the programme (alternately)
■
The indicator light for the i-DOS
settings, if intelligent dosage has
been selected
■
Information on water and energy
consumption
In appliances with a
drum light
:
The drum is lit after switching on the
appliance, after opening and closing the
door and after starting the programme.
The light switches off automatically.
Placing laundry into the drum
:
Warning
Danger of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse these items of laundry
thoroughly beforehand.
Notes
■
Mix items of laundry of varying sizes.
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual laundry
items may cause an unbalanced
load.
■
Observe the maximum specified
load. Overfilling adversely affects the
washing result and promotes
creasing.
1.
Unfold presorted laundry items and
place them in the drum.
2.
Make sure that no items of laundry
are trapped between the door and
the rubber seal, and close the door.
The
A
button indicator lamp flashes
and the programme settings appear in
the display panel.
Measure and add detergent
and care products
The washing machine doses your
detergent and fabric softener
automatically in most programmes.
The intelligent dosage has been preset
at the factory for all programmes in
which it can be used.
You can use these default settings or
In addition to intelligent dosage,
cleaning aids (e.g. stain remover) can
be added manually to compartment
v
u
, if necessary.
For programmes that cannot be used
with intelligent dosage, or if you would
prefer to dose manually (in which case
set intelligent dosage to "off"
ö
), add
detergent to compartment
v
u
.
