Home Connect
en
55
3.
Press
Inicio/Pausa+Carga
.
a
The display shows
Delayed start
.
4.
Press
Inicio remoto
.
a
If the display shows
Flex Start
,
Flex Start is activated and the ap-
pliance waits to be started by the
smart energy system (energy man-
ager).
a
If the display changes to
: Ready
in approx.
, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a
If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following
circumstances:
¡
Press
Inicio/Pausa+Carga
.
¡
Open the door.
¡
Switch off the appliance.
¡
Power failure.
16.6 Activating Wi-Fi on the
appliance
Note:
When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1.
Press and hold
Inicio remoto
for
approx. 3 seconds.
2.
Select
Wi-Fi On/Off
.
3.
Select
on
.
a
Wi-Fi is activated.
Notes
¡
If Wi-Fi is activated, the appliance
will not switch itself off automatic-
ally.
¡
If Wi-Fi is activated, the appliance
will not switch itself off automatic-
ally.
16.7 Deactivating Wi-Fi on the
appliance
1.
Press and hold
Inicio remoto
for
at least 3 seconds.
2.
Select
Wi-Fi On/Off
.
3.
Select
off
.
a
Wi-Fi is deactivated
Note:
If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
16.8 Software update
Requirement:
The display shows
A
new software version is available.
Do you want to update the software
now? This may take several
minutes.
.
1.
Press and hold
Inicio remoto
for
approx. 3 seconds.
2.
Select
Software update
.
3.
Select
Install now
.
a
The software update starts.
Note:
The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
16.9 Resetting the appliance
network settings
1.
Press and hold
Inicio remoto
for
at least 3 seconds.
2.
Select
Network settings
.
3.
Select
Reset
.
a
The network settings are reset.
Содержание WAV28EH0ES
Страница 65: ...Cleaning and servicing en 65 3 Connect the water inlet hose and check for leaks ...
Страница 82: ......
Страница 83: ......