Operating the appliance
en
31
Easy-Iron
Q
Reduces creasing thanks to a special
spin sequence followed by fluffing and
reduced spin speed.
Note:
The washing's residual moisture
is increased.
Water&Rinse+
ë
Adjustment values:
Higher water level and additional rinse
cycles depending on the programme,
longer programme duration for
particularly sensitive skin and/or for
areas with very soft water.
Prewash
T
For heavily soiled laundry.
Note:
Pour detergent into
compartments
I
and
II
.
Rinse hold
$
If final spinning is not selected, the
laundry will remain in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
To continue/end the programme
1
Operating the
appliance
Operating the appliance
Preparing the washing
machine
Note:
The washing machine
must be
correctly installed
and
connected
.
From
1.
Connect the mains plug.
2.
Turn on the water tap.
3.
Open the door.
4.
Check that the drum is completely
drained. Drain if necessary.
Switching on the appliance/
selecting a programme
Press the
#
button. The appliance is
switched on.
The
Cottons
programme set at the
factory is then always displayed.
The current settings and programme
information light up at full brightness
and the display
A
flashes.
The settings that can be selected light
up at half brightness.
Notes
■
Temporary flashing of the display
Û
informs you to run the programme
Drum Clean
or any other
programme soon at a washing
temperature of at least 60 °C.
■
If the
E
3 sec display flashes, the
childproof lock is active.
You must deactivate this first before
you can change settings or start the
programme.
+1
+ 1 rinse
+2
+ 2 rinses
+3
+ 3 rinses
off
Setting deselected
