Bosch WAT Series, Инструкция по эксплуатации и руководство по установке

Страница: 31 / 58

Operating the appliance
en
31
Change the programme
default settings
To change the current settings, touch
the required control panel; the relevant
display switches to full brightness.
You can change Finished in-time by
touching
N
or
M
.
Note:
The i-DOS settings are saved
until they are changed again, even if the
washing machine is switched off.
Programme default settings
~
Page 26
Select additional programme
settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
To do this, touch the required control
panel; the relevant display switches to
full brightness.
Additional programme settings
~
Page 29
Placing laundry into the drum
:
Warning
Danger of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse these items of laundry
thoroughly beforehand.
Notes
■
Mix items of laundry of varying
sizes.Laundry items of different sizes
distribute themselves better during
the spin cycle.Individual laundry
items may cause an unbalanced
load.
■
Observe the maximum specified
load. Overfilling adversely affects the
washing result and promotes
creasing.
1.
Unfold presorted laundry items and
place them in the drum.
2.
Make sure that no items of laundry
are trapped between the door and
the rubber seal, and close the door.
Measure and add detergent
and care products
For the majority of programmes on your
washing machine, detergent and fabric
softener are dosed automatically; it is a
factory setting for these programmes
and can be changed.
In addition to intelligent dosing, you can
add cleaning aids (e.g. softener, bleach
or stain remover) to the left-hand
compartment , if necessary.
For programmes without intelligent
dosing, or as required (in which case,
set intelligent dosing to "off"), detergent
can be added manually to the left-hand
compartment.
Start the programme
Touch the control panel
A
.
The programme starts and the
A
display lights up permanently.
The door is locked and the
corresponding display
è
lights up.