en
Faults and what to do about them.
26
Information on the display
panel
Faults and what to do about
them.
Display
Cause/remedial action
YES
The washing machine door is unlocked. It is possible to add laundry.
NO
■
Temperature too high. Wait until the temperature drops.
■
Water level too high. Not possible to add laundry. Close the washing machine
door immediately, if open. Select
Start
/Pause to continue the programme.
¼
flashes
■
Laundry may be caught. Please open and close the washing machine door
again and select
Start
/Pause.
■
If necessary, push the washing machine door closed or remove the laundry and
push it closed again.
■
If required, switch appliance off and on again; set the programme and make
individual settings; start the programme.
E:17
■
Turn the water tap on fully,
■
supply hose kinked or trapped,
■
water pressure too low. Clean the filter.
E:18
■
Detergent solution pump blocked. Clean detergent solution pump.
■
The drain hose/waste pipe is blocked. Clean the drain hose on the siphon.
E:23
Water in the base tub, appliance leaking. Turn off the tap. Call the after-sales ser-
vice.
E
Childproof lock activated; deactivate it.
9
flashes
Too much foam detected, a rinse cycle has been switched on
Other displays
Switch off appliance, wait five seconds and switch on again. If the display is indi-
cated again, call the after-sales service
Faults
Cause/remedial action
Water is leaking out.
■
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
No water supply.
Detergent not dispensed.
■
Start
/Pause not selected?
■
Tap not turned on?
■
Filter blocked? Clean the filter.
■
Supply hose kinked or trapped?
Washing machine door
cannot be opened.
■
Safety function active. Programme stopped?
■
– – –
0
(Rinse hold = without final spin) selected?
■
Содержание WAK20268EE
Страница 1: ...en Instruction Manual and Installation Instructions Washing machine WAK20268EE ...
Страница 38: ...6 ...
Страница 39: ...6 ...