Bosch WAK2022SEG, Инструкция по эксплуатации и руководство по установке

Страница: 26 / 38

en
Faults and what to do about them.
26
Faults and what to do about them.
Faults Cause/remedial action
Water is leaking out.
■
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
No water supply.
Detergent not dispensed.
■
Start /Pause
A
not pressed?
■
Tap not turned on?
■
Filter blocked? Clean the filter.
■
Supply hose kinked or trapped?
Washing machine door
cannot be opened.
■
Safety function active. Programme stopped?
■
– – –
0
(Rinse hold = without final spin) selected?
■
Can be opened by emergency release only?
Programme does not
start.
■
Start
/Pause
A
pressed or
"Ready in"
time selected?
■
Washing machine door closed?
■
E
Childproof lock activated? To deactivate:
Detergent solution is not
emptied.
■
– – –
0
(Rinse hold = without final spin) selected?
■
Clean the detergent solution pump.
■
Clean the waste pipe and/or drainage hose.
Water not visible in the
drum.
Not a fault – water below the visible area.
Spin result not satisfac-
tory.
Laundry wet/too damp.
■
Not a fault – the unbalanced load detection system has interrupted the spin
because the laundry is unevenly distributed.
Distribute large and small items of laundry evenly in the drum.
■
Q
Easy Iron (depending on the model) selected?
■
Speed selected too low?
Spin cycle started and
stopped several times.
Not a fault – the unbalanced-load detection system is adjusting the imbalance.
The programme duration
is longer than usual.
■
Not a fault – the unbalanced-load detection system is adjusting the imbal-
ance by repeatedly distributing the laundry.
■
Not a fault – the foam detection system active – adds an additional rinse
cycle.
The programme duration
changes during the wash
cycle.
Not a fault – the programme sequence is optimised for the particular washing
process. This may lead to changes in the programme duration in the display
panel.
Residual water in the
compartment
i
for care
products.
■
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary.
Odours in the washing
machine.
Run the
i
Cottons 90 °C
programme without laundry.
Use standard detergent.