Bosch WAJ24006GB, Руководство пользователя и инструкции по установке

Страница: 14 / 56

en
Installation and connection
14
ATTENTION!
¡
If the appliance is installed in
areas exposed to frost or out-
doors, frozen residual water may
damage the appliance and frozen
hoses may crack or split.
▶
Do not install or operate this ap-
pliance anywhere that is liable to
experience frost and/or out-
doors.
¡
The appliance underwent a func-
tion test before leaving the factory
and may, therefore, contain resid-
ual water. This residual water may
leak out if the appliance is tilted at
an angle greater than 40°.
▶
Tilt the appliance carefully.
Installation location Requirements
On a base Secure the appliance
with fixing brackets
→
Page 26 .
On a wooden joist
floor Place the appliance
on a water-resistant
wooden board which
is screwed tightly to
the floor. The wooden
board should be at
least 30 mm thick.
In a kitchen unit ¡ A niche width of
60 cm is required.
¡
Only install the ap-
pliance under-
neath a continuous
worktop that is se-
curely connected
to adjacent cabin-
ets.
Installation location Requirements
On a wall Do not trap the hoses
between the wall and
the appliance.
Note:
If you want to install the wash-
ing machine with a dryer as a
washer-dryer stack, your washing ma-
chine's worktop must be replaced
first.
To replace the worktop, please con-
tact customer service →
Page 51 .
Removing the transit bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Notes
¡
Please read the safety information
→
Page 4 to ensure that you use
the appliance safely.
¡
Keep the transit bolts, screws and
sleeves in a safe place for future
transport →
Page 49 .
1.
Pull the hoses out of the holders.
2.
Unscrew and remove all four
screws for the transit bolts with a
WAF 13 wrench.