Bosch WAE20067ES, Инструкция по эксплуатации и руководство по установке

Страница: 30 / 36

en
Cleaning and maintenance
30
Refit and screw on the pump cover.
The handle must be in a vertical
position.
6.
Put the service flap back on, lock it
into place and close it.
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment
II
and start the
Empty
programme.
The drain hose at the siphon
is blocked
1.
Switch off the appliance. Pull out the
mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply
blocked
:
Warning
Risk of electric shock!
Do not immerse the AquaStop safety
valve in water (it contains an electric
valve).
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any programme (except
Rinse/Spin/Empty
).
3.
Press the
Start button
. Allow the
programme to run for approximately
40 seconds.
4.
Set the programme selector to the
Off
position. Pull out the mains plug.
5.
Clean the filter on the tap:
Disconnect the hose from the tap.
Clean the filter with a small brush.
6.
For standard and AquaSecure
models, clean the filter on the rear of
the appliance:
Disconnect the hose from the rear of
the appliance,
Use pliers to remove the filter and
then clean it.
7.
Connect the hose and check for
leaks.