Bosch VideoJet X10, Инструкция по установке и эксплуатации

Страница: 80 / 132

80 en | Configuration Using a Web Browser VideoJet X10
V3.0 | 2007.09 Installation and Operating Manual Bosch Security Systems
5.28.14 SNMP
The VideoJet X10 supports the SNMP V2 (Simple Network Management Protocol) for
managing and monitoring network components, and can send SNMP messages (traps) to IP
addresses. The unit supports SNMP MIB II in the unified code. If you wish to send SNMP traps,
enter the IP addresses of one or two required target units here.
If you select
On for the SNMP parameter and do not enter an SNMP host address, the
VideoJet X10 does not send them automatically, but only replies to SNMP requests. If you
enter one or two SNMP host addresses, SNMP traps are sent automatically. Select
Off to
deactivate the SNMP function.
5.28.15 1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP addresses of one or two required
target units here.
5.28.16 SNMP traps
You can select which traps are to be sent.
1.
Click Select . A new window will open.
2. Click the checkboxes to select the required traps. All the checked traps will be sent.
3. Click OK to apply the selection.
5.28.17 Authentication
If a RADIUS server is employed in the network for managing access rights, authentication must
be activated here to allow communication with the unit. The RADIUS server must also contain
the corresponding data.
To configure the unit, you must connect the VideoJet X10 directly to a computer using a
network cable. This is because communication via the network is not enabled until the
Identity and Password parameters have been set and successfully authenticated.
5.28.18 Identity
Enter the name that the RADIUS server is to use for identifying the VideoJet X10.
5.28.19 Password
Enter the password that is stored in the RADIUS server.
5.28.20 Automatic IP assignment
If a DHCP server is employed in the network for the dynamic assignment of IP addresses, you
can activate acceptance of IP addresses automatically assigned to the VideoJet X10.