aus
Troubleshooting
46
17 Troubleshooting
You can rectify minor faults on your appliance yourself. Read the troubleshoot-
ing information before contacting after-sales service. This will avoid unneces-
sary costs.
WARNING
Risk of electric shock!
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out by trained specialist
staff.
▶
Only use genuine spare parts when repairing the appliance.
▶
If the power cord of this appliance is damaged, it must be replaced with a
special connection cable, which is available from the manufacturer or his
Customer Service.
Fault
Cause and troubleshooting
Appliance door does
not open at the end of
the programme.
Automatic door opening is not activated.
▶
Activate the automatic door opening.
→
"Overview of basic settings", Page 36
Door is not correctly adjusted.
▶
Adjust the appliance door as described in the in-
stallation instructions.
The door gap must be at least 70 mm - 100 mm.
Appliance door and door seal are soiled.
▶
Clean the appliance door and door seal with a
damp cloth and a little washing-up liquid.
Wrong screws used to adjust the door gap.
▶
Use size 4X30 bolts to adjust the door gap.
The bolts are included in the scope of supply.
If you use bolts that are too long, this can deactiv-
ate the function of automatic door opening.
The safety device switches off automatic door open-
ing.
▶
Call Customer Service. →
Appliance door brushes against the appliance or kit-
chen cabinets
▶
Install the appliance correctly as described in the
installation instructions and align.
Appliance door opens
too wide at the end of
the programme.
Door is not correctly adjusted.
▶
Adjust the appliance door as described in the in-
stallation instructions.
The door gap must be at least 70 mm - 100 mm.
