NLSoftening System
PAY ATTENTION!
†Dishwasher detergent can damage the water
damage hardening.
▶
Only fill the water softener
reservoir with dishwasher
softening salt.
†The rinse aid container can be
corrode softening salt.
▶
To ensure that spilled softening
salt is rinsed out of the rinse aid
container, fill the softening salt
into the softening salt reservoir
immediately before the program
starts.
4.
Fit and close the lid of the
reservoir.
Switch off water softening
If the refilling salt indicator bothers
you, for example if you use a
combined dishwasher detergent with
a salt component, you can switch off
the indicator.
Note
To avoid damage to the
appliance, only switch off the
water softening in the following
cases:
†The water hardness is maximum
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. According to
the manufacturer's instructions,
combined dishwasher detergents
with salt substitutes can only be
used up to a degree of hardness of
21 °dH without adding softening
salt.
†The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
1.
Open the lid of the softening salt
reservoir and remove it.
2.
When using for the first time: fill the
reservoir completely with water.
3. NoteOnly use dishwasher
softening salt.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.
1.
Press.
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
a
aThe display shows Hxx. aThe
display shows
reflected
to give.
3.
Just as often on
the display shows H00.
press until
4.
To save the settings, press . for
about 3 seconds
to press.
aThe water softener has been
switched on and the refill
softener salt indicator is
deactivated.
Funnel
1
The reservoir for softening salt
fill completely with softening salt
t reservoir
n flows away.
len. The water in
him is displaced e
1
Depending on the
device version
26
