Transport and storage 19/28
RE 29681-B/11.2019; VT-SVTSY-1-1,
Bosch Rexroth AG
6 Transport and storage
There are no special transport instructions for this product. However, always
observe chapter 2 “Safety instructions“ and comply with the ambient conditions
specified in the data sheet for storage and transport.
Bosch Rexroth recommends keeping and transporting the test device and the
accessories in the case included in the scope of supply.
7
Installation
NOTICE
Condensed water!
Risk of short-circuit
▶
Allow the test device to acclimatize for several hours to prevent formation of
condensed water in the housing of the test device.
Penetrating humidity!
The housing of the test device is enclosed. Nevertheless, according to the
applicable ingress protection class, fluids may enter and lead to faults and short-
circuit. This will result in the fact that safe operation of the test device can no
longer be ensured.
▶
When working with the test device, always ensure that no fluids can enter the
electronics housing.
Major potential differences!
Risk of destroying the electronics by connecting or disconnecting plug-in
connectors under voltage.
▶
Switch off the power supply to the relevant system part before assembling the
device or when connecting and disconnecting connectors.
7.1 Unpacking
Dispose of the packaging in accordance with the national regulations of your
country.
7.2 Installation conditions
▶
For installing the product always observe the environmental conditions
specified in the technical data sheet.
NOTICE
: The environment must be free from aggressive substances (acids, bases,
corrosive agents, salts, metal vapors, etc.) which may enter the device despite
compliance with the relevant protection class.
▶
Before commissioning, make sure that all the seals and plugs of the plug-in
connections are correctly installed to ensure that they are leak-proof and no
fluids or foreign particles can enter the product.
