Bosch Rexroth IndraMotion MTX 11 VRS, Руководство по применению, Страница: 157 / 304

Additive Value Entry <Additive value entry> can be used to enter D-correction values that are to be
added to the existing value (see section chapter "Value Entry" on page 143 ).
7.5.5 Placements
General Information on Placements
The placement editor is used to display and enter offset values (X, Y, Z) and
turning angles (phi, theta, psi). A comment with a maximum of 32 characters
can be assigned to each correction value.
Fig.7-34: Placement editor
Number of Correction Pages
A placement table can contain a maximum of 5 correction pages, each of which
contains offset values G154.x to G159.x.
Unit of the Table (mm/inch) he unit of a placement table can be determined on the basis of the column
headers of X, Y and Z ([mm] or [inch]). Turning angles phi, theta and psi have
a unit of [°].
The unit of a D-correction table is already determined from param‐
eter 9020 00010 of the configuration data during the creation of the
table and is stored with the table.
Number of Decimal Positions The number of decimal positions displayed is specified by parameters 6020
00021 and 6020 00022 in the configuration data.
Operating the Placement Editor
General
Only the functions affecting the placement editor are described here. The gen‐
eral operation of table editors is described in chapter 7.5.2 "Operation" on page
143 .
function keys in the Placement Editor
The following table shows all function keys of the placement editor:
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation Bosch Rexroth AG 155/301
Programming