3-10
Safety Instructions for Electric Drives and Controls
MPH-02, MPB-02, MPD-02
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
3.9
Protection Against Contact with Hot Parts
CAUTION
Housing surfaces could be extremely hot!
Danger of injury! Danger of burns!
⇒
Do not touch housing surfaces near sources of heat!
Danger of burns!
⇒
After switching the equipment off, wait at least ten (10)
minutes to allow it to cool down before touching it.
⇒
Do not touch hot parts of the equipment, such as
housings with integrated heat sinks and resistors.
Danger of burns!
3.10 Protection During Handling and Mounting
Under certain conditions, incorrect handling and mounting of parts and
components may cause injuries.
CAUTION
Risk of injury by incorrect handling! Bodily
harm caused by crushing, shearing, cutting and
mechanical shock!
⇒
Observe general installation and safety instructions
with regard to handling and mounting.
⇒
Use appropriate mounting and transport equipment.
⇒
Take precautions to avoid pinching and crushing.
⇒
Use only appropriate tools. If specified by the product
documentation, special tools must be used.
⇒
Use lifting devices and tools correctly and safely.
⇒
For safe protection wear appropriate protective
clothing, e.g. safety glasses, safety shoes and safety
gloves.
⇒
Never stand under suspended loads.
⇒
Clean up liquids from the floor immediately to prevent
slipping.
Courtesy
of
CMA/Flodyne/Hydradyne
▪
Motion
Control
▪
Hydraulic
▪
Pneumatic
▪
Electrical
▪
Mechanical
▪
(800)
426-5480
▪
www.cmafh.com
