Bosch Rexroth IndraDrive Mi KCU02, Руководство по планированию проекта

Страница: 47 / 422

2 Important directions for use
2.1 Intended use
2.1.1 Introduction
Rexroth products are developed and manufactured to the state-of-the-art.
The products are tested prior to delivery to ensure operational safety and
reliability.
Personal injury and property damage by
using products incorrectly!
WARNING
The products have been designed for use in an industrial environment and
may only be used as intended. Failure to use them in the intended way may
cause situations resulting in property damage and personal injury.
Rexroth as the manufacturer shall not honor any warranty, liability
or compensatory claims for damages resulting from unintended
use of the products. The user alone shall bear the risks of
unintended use of the products.
Before using Rexroth products, make sure that all the prerequisites for an
intended use of the products are satisfied:
●
Personnel that in any way, shape or form uses our products must first
read and understand the relevant safety instructions and be familiar with
their intended use.
● Leave hardware products in their original state, i.e., do not make any
structural modifications. It is not permitted to decompile software
products or alter their source codes.
● Do not install damaged or faulty products or put them into operation.
● Make sure that the products have been installed as described in the
relevant documentation.
2.1.2 Areas of use and application
Drive controllers by Rexroth are designed to control electric motors and
monitor their operation.
Controlling and monitoring the Drive controllers may require additional
sensors and actuators.
The drive controllers may only be used with the accessories and
attachments specified in this documentation. Components that
are not expressly mentioned may neither be attached nor
connected. The same applies to cables and lines.
Operation is only allowed in the specified configurations and
combinations of the components using the software and firmware
as specified in the relevant functional descriptions.
Drive controllers have to be programmed before commissioning to ensure
that the motor executes the functions specific to the application.
Drive controllers of the IndraDrive Mi series have been developed for use in
single- and multi-axis drive and control tasks.
IndraDrive Mi Drive Systems with KCU02, KSM02,
KMS02/03, KMV03, KNK03, KLC03
33/407
Important directions for use
R911335703_Edition 04 Bosch Rexroth AG