Bosch Rexroth IndraControl VDP 15.3 Multi Touch, Руководство по эксплуатации

Страница: 31 / 44

10.6.3 Overall connection scheme
X10
UPS 230V 24V
24V
24V
Out
24V
In 230V~
+
-
+
-
U
+
-
+
-
1
2
3
USB cable
X1S1/2 (GND)
X1S1/1 (24VDC)
XSER
XVID
XSER
XVID
Operator display
XUSBIN, type B XUSB1..6
XUSB1...4
Front panel
USB connection
USB connection
Type B
USB connection
Type A
for USB2.0, max. 5 m
Control cabinet PC
External power
supply unit
(as option)
Fig. 10-10: Connection diagram with power supply unit, UPS, control cabinet PC and opera-
tor display
10.6.4 Recommendation for the mounting of CDI cables with long
lengths in an interference-prone environment
The CDI cable is a connection cable with RJ45 plug to connect the CDI interface
of the control cabinet PC to the remote operator display or the Y-repeater.
These mounting recommendations facilitate an optimized signal transmission. In
particular in case of great cable lengths and distances between the control cabi-
net PC and the remote operator display, ensure that the cable is installed cor-
rectly and that the shield is connected correctly.
Cables routing
Observe the following when routing cables:
●
Keep the maximum possible distance to interference-prone cables and lines
●
Limit parallel routing with other lines
●
Keep the maximum possible distance to sources of interference such as
drives and frequency converters
●
Mechanical protection against tensile and compressive load on the cables
●
Comply with the permissible bending stress and torsional stress of the cable
●
Avoid collection of dirt at the R45 plug which can occur while drawing the ca-
bles into the system.
Potential equalization
Ensure that no compensating current flows via the cable shield of the CDI cables
between device and machine parts during the installation of the equipotential
bonding.
Bosch Rexroth AG
Mounting, demounting and electric installation
DOK-SUPPL*-VDPXX.3MTBU-IT03-EN-P
25/37