Bosch Rexroth IndraControl VAM 11.1, Руководство по планированию проекта

Страница: 53 / 86

VAM 11.1/VAM 41.1 wiring
10 mm² (green/yellow)
6 mm² (blue)
PE bar
A
B
A
Overvoltage category I
6 mm²
n
to be connected to FE of VAM .
6 mm²
a to be connected to FE of VPB 40.3, VPP xx.3, VSB 40.3, VSP xx.3 .
6 mm²
a to be connected to FE of the UPS (VAU 01.1U) .
FE = Functional earth
X1S1
+
FE
X10
FE
10 mm²
A=
B=
(1)
(3)
(4)
(1)
(4)
(3)
(3)
Easily removable and visible
VAM
U
Q
U
L
6 mm² (blue)
A
A
(4)
0 V
(4)
U
Q
Terminal block UK6-FSI/6
with automatic cut-out TCP 2 A
(PHOENIX CONTACT)
is recommended.
1
2
3
4
1
2
3 PLC
(1)
U
L
0 V
Non-isolated
terminal block
Isolated
terminal block
Polarity reversal of the X1S1 and X10 connectors can destroy the device,
if there is not additional external protection (fire danger). This is caused by the
simultaneous grounding of the 0 V of the device and of the 0 V (PELV) (1).
Cable length between 24 V power supply unit and VAM max. 6 m at a minimum
cross-section of 0.75 mm .
Cable length between 24 V power supply unit and VAM max. 10 m at a minimum
cross-section of 1.5 mm .
An additional power supply unit is required if the length exceeds
2
Power
supply
unit
(green/yellow)
2
10 m.
Fig.7-8: VAM 11.1/VAM 41.1 wiring
7.4 X71: Fieldbus Interface PROFIBUS DP
7.4.1 General Information
Connector X71 provides at connection VP 5 V / 100 mA ISO voltage. Do not
use any bus terminating resistors, but only a bus load. Thus, the connection of
a hand-held terminal or of an Optical Link Plug (OLP) [conversion RS485/Opto]
is possible.
Optical PROFIBUS networks in ring topology can be established with the help
of the OLP.
Fieldbus interface
Type RS485
Electrical isolation Yes
Baud rate Up to 12 Mbaud
2 BCD rotary switches Station address 1-99
Connector X71 9-pin female connector strip D-SUB
Fig.7-9: Fieldbus interface PROFIBUS DP according to EN 50170, Part 2 (DP)
DOK-SUPPL*-VAM*11/41**-PR03-EN-P
Rexroth IndraControl VAM 11.1/41.1 Machine Control Panels Bosch Rexroth AG 51/83
Interfaces