Bosch rexroth IndraControl VAC 08.1, Руководство по эксплуатации

Страница: 11 / 40

NOTICE
In case of non-compliance with this safety instruction, material damage can
occur.
3.3 Symbols used
Pointers are displayed as follows:
This is a note.
Tips are displayed as follows:
This is a tip.
3.4 Explaining the signal alert symbol on the device
krax
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
4 Intended use
The CDI+ splitter is required to connect two operator displays to a PC with
HDMI, display port or DVI-D monitor interface.
Risk of damaging the device if not expressly sta-
ted accessories, mounting parts and other com-
ponents, cables and lines are used.
NOTICE
The CDI+ splitter may be used only as intended and with the accessories,
mounting parts and other components specified in this documentation. Compo-
nents that are not expressly mentioned must neither be attached nor connected.
The same applies to cables and lines.
Operation must only be carried out with the hardware component configura-
tions and combinations that are expressly specified.
The CDI+ splitter can be used for the following IndraControl V device:
●
Control cabinet PC Rexroth IndraControl VPB 40.4 and PR4
●
Panel PC VR4
IndraControl VAC 08.1 CDI+ Splitter 5/33
Intended use
R911400465_Edition 01 Bosch Rexroth AG