RE 63124-B, Edition: 08.2021, Bosch Rexroth AG
Transport and storage |
Press modules Type IH04 23/56
Transport with cranes is carried out using attachment devices such as lifting straps,
belts or chains. The edges of the press module can permanently damage the straps.
▶ Therefore, use edge protection.
The use of bare chains may cause scuffing to the surface.
▶ Protect these surfaces with appropriate means such as blankets.
▶ Lift and lower the press module slowly and carefully.
▶ Only lift the press module as far off the floor as necessary.
6.2 Storing the press module
▶ Comply with the storage conditions specified in the following table.
Table 6: Storage conditions
Denomination
Range
Temperature range
+10 to +40 °C
Relative air humidity (no condensation)
Max. 65%
The press module is suitable for storage for up to 6 months under the following
conditions:
▶ Do not store the press module outdoors but in a well-ventilated room.
Avoid high light irradiation.
▶ Protect the press module against humidity, particularly ground humidity.
Store the press module on a shelf or on a pallet.
▶ Observe the admissible load-bearing capacities of your storage system.
▶ Store the press module in the original packaging or comparable packaging.
▶ Make sure that all connections on the press module are closed with cap elements.
▶ After opening the transport packaging, it must be closed properly again for
storage. Use the original packaging for storage.
▶ Do not remove covers from the hydraulic connections on the press module until
just before assembly.
▶ For storage periods longer than 6 months, consult with Bosch Rexroth.
After expiry of the maximum storage time, Bosch Rexroth recommend having
the press module checked by your competent Rexroth service.
Storage conditions
Storage up to 6 months
Storage longer
than 6 months
