Bosch Rexroth CytroMotion, Руководство по эксплуатации

Страница: 23 / 60

23 / 60
Self-contained axis
Storage
Bosch Rexroth AG RE62290-B, 05.22
6 Transport and storage
6.1 Transport
WARNING
Heavy weight and sharp edges of the self-contained
axis! The components are heavy (> 100 kg). If handled
improperly, they may fall down and cause serious inju-
ries and/or crushing injuries as the components may e.g.
have sharp edges, be heavy, oily, loose or bulky.
−
Transport the components to their intended locations
using suitable lifting gear.
−
All lifting gear has to be subjected to a visual inspec-
tion before every use.
−
Only authorized and instructed personnel may use
and apply the lifting gear and load lifting devices.
−
Provide for a stable position during transport to the
place of installation.
−
Wear personal protective equipment when trans-
porting the components.
−
Comply with the national laws and regulations
regarding occupational health and safety for the
transport.
−
Do not stand or walk under lifted loads.
CAUTION
No stability! Danger of injuries and crushing by a self-
contained axis toppling over.
−
Transport and store the components only in appro-
priate packaging.
−
Only lift the component by the lifting/attachment
points provided for that purpose.
−
Always use several attachment devices for trans-
porting the self-contained axis.
In transport, consider the following aspects:
●
Properties of the load (e.g. weight, center of gravity, mounting and attach-
ment points).
●
Type of attachment or pick-up of the load.
The system may only be transported if the requirements listed in this
chapter are observed. Only the attachment points shown in the
⮫
data sheet
of the self-contained axis may be used.
To ensure proper and safe transportation, only use attachment devices which
are appropriate for the weight.
The position of the tapped holes for the attachment devices is shown in the
⮫
data sheet of the self-contained axis.
6.2 Storage
The self-contained axis should preferably be stored in the unopened original
packaging.
Comply with the storage times, see the following table.
Table 4: Storage times
Storage conditions Packaging Protective agent Max. storage time in months
Test with protec-
tive agent
Filling with protec-
tive agent