Safety instructions
9/32
3 842 560 864/2021-10, ActiveShuttle: Lithium-ion battery, Bosch Rexroth AG
2.6
Product-specifi c safety instructions
• Do not attempt to modify the product (software or hardware).
• Do not expose the product to any mechanical loads under any circumstances.
Never use the product as a handhold or step. Do not place any objects
on the product.
• Always secure the product against tipping over.
• Observe the transport instructions on the packaging.
• Inspect the product for obvious transport damage.
• Make sure the system component you are working on is depressurized and
de-energized before assembling the product or inserting or removing plugs.
• Allow the product to acclimatize for a few hours prior to commissioning in order to
prevent water condensation from forming in the housing.
• Only start up a product that has been completely installed.
• Make sure that all the safety equipment which forms part of the product is present,
has been properly installed, and is fully functional. Do not move, bypass or disable
any safety equipment.
• Check the product for malfunctions.
• Make sure that only authorized personnel perform the following tasks within the
scope of the product’s intended use:
– Starting or operating the system or interfering with its normal operation.
– Operating component or part adjusters.
• Only allow people to be in the immediate vicinity of the product when it is
operating if they are authorized by the owner to be there. This also applies when
the product is idle.
• Do not reach into moving parts.
• An idle system is not necessarily a safe system, as stored energy can be released
unintentionally or through improper maintenance procedures.
• After a malfunction, only switch the system back on once you have established and
rectifi ed the cause of the fault.
• Make sure that access to maintenance and inspection points is kept unobstructed.
• Make sure that no line connectors, connections or components are disconnected
as long as the system is supplied with pressure and voltage. Secure the system
against being switched back on.
• Dispose of the product in accordance with the regulations in your country.
General
During transport
During assembly
During commissioning
During operation
EMERGENCY STOP,
malfunction
During servicing
and repair
During disposal
EN
GLISH
