Bosch Rego 1000, Руководство пользователя

Страница: 4 / 24

Rego 1000 – 6 721 831 662 (2021/03) en 4
Control panel
2 Control panel
Settings for the control of the heat pump are made with the control unit's
control panel, which also provides information about current status.
2.1 Panel overview
Fig. 1 Control panel
[1] On/Off button
[2] Mode button
[3] Info button
[4] Menu dial
[5] Status lamp
[6] Return button
[7] Menu button
[8] Menu display
2.2 Power switch (ON/OFF)
Use the On/Off button to turn the heat pump on and off.
2.3 Status lamp
2.4 Menu display
Use the menu display in order to:
• See information from the heat pump.
• See available menus.
• Change set values.
2.5 Menu button and menu dial
Use to get from Initial menu to the menus. Use the menu dial in
order to:
• Navigate the menus and get to the setting displays.
– Turn the dial to see more menus on the same level or change a set
value.
– Press the dial to change to a lower menu level or save a change.
2.6 Return button
Use to:
• Go back to the previous menu level.
• Leave a setting display without changing the set value.
2.7 Mode button
Use to change type of operation.
• Change type of operation.
2.8 Info button
Use to see information from the control unit about operating
mode, temperature, program version, etc.
3 Menu navigation
3.1 Initial menu
Initial menu shows different temperatures, time, as well as current
operating symbols. The window displays information alternately
Room
temperature (if room sensors exist) and Flow temperature for each
circuit installed.
Fig. 2 Initial menu
[1] Outdoor temperature
[2] Current operating symbols
[3] The circuit room temperature
[4] Current time
[5] Hot water temperature
[6] Circuit flow temperature
[7] Circuit number
Fig. 3 Initial menu, circuit 2 is displayed
3.2 Finding desired function and changing value
Menu overview (

Page 7) shows the main functions that are reached
with and the dial.
▶ Press .
Fig. 4
The lamp lights green. The heat pump is running.
The lamp flashes red . There is an alarm which has not been
acknowledged.
The lamp lights red. The alarm has been acknowledged
but the alarm cause remains.
The lamp flashes slowly green,
menu window not lit. The heat pump is in stand-by mode
1)
.
1) Stand-by means that the heat pump is running but no heating or hot water
demand exists.
The lamp and menu display not
lit. No voltage to the control unit.
Table 2 Lamp functions
mode
info
menu
ok
1
2
3
4
6
5
7
8
6 7 20 643 420-01.1I
The controller language can be changed with the
button.
▶ Press the button in the initial menu for at least
5 s, then select the required language.
6 720 805 492-01.1I
7
6 720 805 492-02.1I
6 720 807 583-01.1I