Bosch PRS9A6D70A, Инструкция пользователя

Страница: 9 / 20

Installation and connection en
9
Caution!
Only use the lever on the edges of the glass that
have a cut-out profile or a frame.
4.
Carefully lift the glass plate with the cut-out profiles
to release the rear clip fastener.
Replacing the outer flame nozzle (fig. 9a):
1.
Undo the fastening screw L1 and pull the sleeve L2
back to provide easy access to the main nozzle
(fig. a1).
2.
Turn the outer flame nozzle anti-clockwise to remove
it (fig. a2-a3).
3.
Screw in the new outer flame nozzle (fig. a3-a4). See
table I.
4.
Set the spacing of the adjustment sleeve for the air
supply L2 to dimension Z, as shown in the table
(fig. a5).
5.
Tighten the fastening screw L1 (fig. a6).
Replacing the inner flame nozzle (fig. 9b):
1.
Unscrew part M3 from part M2, which is threaded.
To do this, counterhold the threaded part (fig. b1).
2.
Remove the sleeve from part M2 (fig. b2).
3.
Remove unit M2-M4 from part M1 (fig. b3-b4).
4.
Remove the inner flame nozzle M4 from part M2
(fig b5-b6).
5.
Screw in the new inner flame nozzle properly (fig. b6-
b7). See table.
Installing the appliance
To fit the components, work backwards through the
instructions for removing them.
Adjusting the gas valves
The gas hob cover and the plug-in board must be
removed before you can adjust the gas valves.
Removing the cover
Remove the glass plate with the cut-out profiles as
described in the section entitled
Removing the glass plate
with the cut-out profiles
.
Removing the plug-in board
The plug-in board is secured to the holder by fastening
pins at the sides and in the middle. Carefully press on
the plug-in board without damaging it. If one of the pins
breaks, the entire holder must be replaced.
Proceed as follows:
1.
Release the pins on one side.
2.
Release the middle pins. To do this, press down on
either side with your fingers.
3.
Release the pins on the other side and remove the
plug-in board.
Caution!
Handle the plug-in board with care. Use anti-static
protection, or handle the plug-in board by its edges.
Never touch the surfaces with components or tracks.
4.
Remove the cylindrical parts and springs from the
gas valve stem.
Adjusting the bypass
If necessary, use a Torx screwdriver to adjust the
bypass screws (M):
A : For Propane the bypass screws must be tightened
properly.
D
D
=
/
D
D D
D
D
E
E
0
0
0
E
E
0
0
E
0
0
0
0
E
0
0
0
0
E
E