Bosch Praesideo 3.5, Инструкция по установке и эксплуатации

Страница: 350 / 498

Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 350
43.3.5 Line and loudspeaker
supervision
43.3.5.1 Adding supervision devices
Proceed as follows to add a supervision device to an
audio output of a power amplifier:
1 Click the
Configure supervision devices button in the
Audio Outputs category of the applicable power
amplifier (see section 43.3.4). A screen similar to the
one figure 43.14 appears.
2 Click the Add button to add a new supervision device
to the audio output. A screen similar to the one in
figure 43.15 appears.
3 Enter the data of the supervision device (see figure
43.16 for an example).
•
Enter a name for the supervision device in the
Name field. The name may consist of up to 16
characters.
• Select the type of supervision device from the
Type dropdown list.
• Enter the address that was assigned to the
supervision device in the
Address field (see figure
43.16).
figure 43.14: Add supervision device, step 1
figure 43.15: Add supervision device, step 2
Note
When you want to use an LBB4441
(PRS-SVLSP) to supervise the loudspeaker line
as well, it is recommended that you install the
LBB4441 in the last loudspeaker in the line. To
enable loudspeaker line supervision, put a check
mark in the Line box. The LBB4441 will then be
polled more often.
Note
It is also possible to add multiple supervision
devices of the same type at the same time by
entering an address range in the Address field,
e.g. 1-6.
figure 43.16: Add
supervision
device, step 3