Bosch Praesideo 3.5, Инструкция по установке и эксплуатации

Страница: 337 / 498

Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 337
42.9 TCP/IP device
42.9.1 Add a TCP/IP device
TCP/IP devices can access the system through the open
interface. When a TCP/IP device is added to the system
definition, it becomes a part of the system and can be
supervised.
Adding a TCP/IP device to the system definition is
similar to adding a power amplifier (see section 42.4).
Go to
Configure > System Definition > TCP/IP device , click
the Add button and:
• Enter a name for the TCP/IP device in the Name
field. The name may consist of up to 16 characters.
• Enter the IP address of the TCP/IP device in the IP
address fields.
• Use the Connection supervision list to specify if the
connection to the TCP/IP device must be supervised
(
On ) or not ( Off ).
TCP/IP devices that are not added to the system
definition can also connect to the Praesideo system
through the open interface when the
Access permission for
non-configured TCP/IP devices is set to Yes (see section
44.4). However, the connection of such a TCP/IP
device to the system is not supervised.
42.9.2 Delete a TCP/IP device
Deleting a TCP/IP device from the system definition is
similar to deleting a power amplifier (see section 42.4.2).
Go to
Configure > System definition > TCP/IP device , select
the TCP/IP device that has to be deleted and click the
Delete button.
Note
Supervised TCP/IP devices must be active
when the system is active. Otherwise, the
system generates a fault event.
figure 42.16: TCP/IP device definition
Note
A maximum of 5 TCP/IP devices with an open
interface access (refer to chapter 54, Open
Interface) can be used with a network controller,
irrespective of being a system element,
supervised or neither. TCP/IP devices can be a
PC call server or a logging server. The
configuration web browser uses a different port
(port 80) for the connection and is not part of
this limitation.