Bosch Praesideo 3.5, Инструкция по установке и эксплуатации

Страница: 336 / 498

Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration en | 336
42.7 Fiber interface
42.7.1 Add a fiber interface
Adding a fiber interface to the system definition is
similar to adding a power amplifier (see section 42.4.1).
Go to
Configure > System definition > Fiber interface , click
the Add button and:
• Enter a name for the fiber interface in the Name field.
The name may consist of up to 16 characters.
• Enter the hexadecimal serial number of the fiber
interface in the
Serial number field.
42.7.2 Delete a fiber interface
Deleting a fiber interface from the system definition is
similar to deleting a power amplifier (see section 42.4.2).
Go to
Configure > System definition > Fiber interface , select
the fiber interface that has to be deleted and click the
Delete button.
42.8 CobraNet interface
42.8.1 Add a CobraNet interface
Adding a CobraNet interface to the system definition is
similar to adding a power amplifier (see section 42.4.1).
Go to
Configure > System definition > CobraNet interface ,
click the Add button and:
• Enter a name for the CobraNet interface in the Name
field. The name may consist of up to 16 characters.
The name is also shown on the display of the
CobraNet interface.
• Enter the hexadecimal serial number of the
CobraNet interface in the
Serial number field.
42.8.2 Delete a CobraNet interface
Deleting a CobraNet interface from the system
definition is similar to deleting a power amplifier
(see section 42.4.2). Go to
Configure > System definition >
Cobranet interface , select the CobraNet interface that has
to be deleted and click the Delete button.
Note
Only PRS-FIN(S) Fiber Interfaces have to be
configured. PRS-FINNA Fiber Interfaces cannot
be configured.
figure 42.14: Fiber interface definition
figure 42.15: CobraNet interface definition