Bosch Plena LBB1990/00, Системное руководство

Страница: 38 / 52

Bosch Security Systems | 2005-04 | 9922 141 10364en
Plena Voice Alarm System | Basic System Manual | Operation en | 38
5.6.6 Distribute the alert message
5.6.6.1 Introduction
Proceed as follows to distribute the default alert
message:
•
Select the zones (see section 5.6.6.2).
• Start the alert message (see section 5.6.6.3).
5.6.6.2 Select zones
Select the zones to which the default alert message must
be distributed with the
Zone select
buttons on the front
of the voice alarm controller (see figure 5.12). A red
LED indicates the zones to which the default alert
message is distributed.
•
If the indicator of a Zone select button is off, the
zone is not selected. Push the button to select the
zone.
• If the indicator of a Zone select button is on, the
zone is selected. Push the button to deselect the zone.
To select all zones, push the
All call
button on the front
panel of the voice alarm controller (see figure 5.17)
5.6.6.3 Start the alert message
Push the
Alert message
button to distribute the message
to distribute the default alert message (see figure 5.18).
The message is only distributed to the selected zones
(see 5.6.6.2).
•
If the red Alert message indicator is off, the alert
message is not distributed. Push the
Alert message
button to distribute the default alert message.
• If the red Alert message indicator is on, the message
is distributed. Push the
Alert message
button to stop
distributing the default alert message.
Note
If no additional action is taken within 10
seconds after the last Zone select button has
been pushed (for example pushing the Alert
message button), the zone selection is
cancelled.
figure 5.16: Zone select buttons
Zone select
Zone1 Zone2
Fault
Reset
EMG
Ack
figure 5.17: All call button
figure 5.18: Alert message button
Indicator test
EMG mic
All call Alert message
Alarm message
Indicator test
EMG mic
Alarm message
All call Alert message