Bosch NKF6 17 series, Руководство пользователя

Страница: 10 / 16

10
Cleaning and care
The information in this section provides help on how best to
care for your hob.
Suitable maintenance and cleaning products can be purchased
from the after-sales service or in our e-Shop.
Ceramic
Clean the hob after each use. This will prevent spills from
burning onto the ceramic.
Only clean the hob when it has cooled down sufficiently.
Use only cleaning agents which are suitable for glass ceramic.
Follow the cleaning instructions on the packaging.
Never use:
■
Undiluted washing-up liquid
■
Detergent intended for dishwashers
■
Scouring agents
■
Harsh cleaning agents such as oven spray or stain remover
■
Abrasive sponges
■
High-pressure cleaners or steam jet cleaners
Ground-in dirt can be best removed with a glass scraper,
available from retailers. Please note the manufacturer's
instructions.
You can also obtain a suitable glass scraper from our after-
sales service or from the e-Shop.
Using special sponges to clean glass ceramic achieves great
cleaning results.
Hob surround
To prevent damage to the hob surround, observe the following
instructions:
■
Use only hot soapy water.
■
Wash new sponge cloths thoroughly before use.
■
Do not use any sharp or abrasive agents.
■
Do not use the glass scraper.
Rectifying faults
Faults often have simple explanations. Please read the
following notes before calling the aftersales service.
Display Fault Measure
Blank There is no power supply. Check the household fuse for the appliance. Check whether there is a
power cut by trying other electronic appliances.
All displays
flash
The controls are damp or an object is
resting on them.
Dry the controls or remove the object.
‹
flashes
when
switched on
The controls are damp or an object is
resting on them.
Dry the controls or remove the object. Switch off the appliance. Switch the
appliance back on.
”‹
Display faulty. Switch the appliance off and back on again after about 30 seconds using
either the household fuse or the circuit breaker in the fuse box. Contact the
after-sales service if this appears on the display again.
”ƒ
The electronics have overheated and
have switched off the corresponding
hotplate.
Wait until the electronics have cooled down sufficiently. Then touch a con-
trol for the hotplate.
”…
The electronics have overheated and
have switched off all hotplates.
Wait until the electronics have cooled down sufficiently. Then touch any
control.
”‰
The hotplate was in operation for too
long and has switched itself off.
You can switch the hotplate back on again immediately.