Installation and connection
en
11
You can adjust the angle of the drawer:
1.
Open the drawer as far as it will go and remove the
container.
2.
Remove the middle screw on both sides.
Note:
If you want to reset to the drawer factory
settings, retain the screws.
3.
Loosen the upper and lower screw on both sides.
Note:
Do not remove screws.
4.
Move the drawer left or right into the desired position
on the bottom screw and tighten the screw.
5.
Retighten all screws.
6.
To check the position, close the drawer and correct
if necessary.
Tips for saving energy
If you follow the instructions below, your appliance will use less power.
Note:
The arrangement of the features does not affect the energy consumption of the appliance.
Installing the appliance
Keep the appliance out of direct sunlight.
The appliance needs to cool less frequently at low ambient tempera-
tures and therefore consumes less power.
Install the appliance as far away as possible from heating elements,
cookers and other heat sources:
3 cm to electric or gas cookers
30 cm to oil or solid-fuel cookers
Select an installation location with a room temperature of approx.
20 °C (68 °F).
Do not cover or block the ventilation openings.
The air on the back wall of the appliance does not warm up so
intensely. The appliance consumes less power if the warm air can
escape.
Ventilate the room daily.
