Tool Tips
Always hold the saw
b y
t h e
i n s u l a t e d
gripping surfaces on the front of the
tool and the switch handle.
Failure to
hold the tool by the insulated gripping
surface may result in electric shock or
electrocution if sawing into a blind area
where live wiring exits.
A l w a y s b e c e r t a i n t h a t s m a l l e r
workpieces are securely fastened to a
bench or other support. Larger panels
may be held in place by clamps on a
bench or sawhorses.
To begin a cut, clearly mark the cutting
line, and rest the front of the footplate
on the work. Engage the switch, and
move the blade into the work using only
enough forward pressure to keep the
blade cutting steadily. Do not force, as
this will not make the saw cut faster; let
the blade do the work.
Choose blades carefully, as the ability of
the jigsaw to follow curves, provide
smoother finishes, or faster cutting is
directly related to the type of blade
used (See your Bosch Dealer).
F o r t i g h t c u r v e s i t i s b e s t t o u s e a
narrow or scroll blade.
When sawing metal or similar materials,
s h u t o f f c h i p b l o w e r a n d a p p l y
coolant/lubricant alongside the cutting
line. Don’t use extraction.
Use of reverse-tooth blade such as the
B o s c h T 1 0 1 B R r e q u i r e s t h e o r b i t a l
setting to be “0” and that downward
pressure be applied to the top of the
saw.
Blade Selection
•
Choose blades carefully, as the ability of
the jig saw to make the fastest cuts, to
follow tight curves, to achieve the
smoothest finish and/or to maximize the
life of the blade are directly related to the
type of blade used.
•
Always use a blade that is appropriate for
the cutting task.
•
Always make a test cut in a piece of scrap
material.
•
Most jig saw blades have upward-pointing
teeth, which helps to pull the jig saw
against the workpiece and minimizes
vibration. Blades with upward-pointing
teeth produce a clean cut on the bottom
of the workpiece.
•
Blades with downward-pointing teeth
(reverse-tooth blade) can be used to
produce a clean cut on the top of the
workpiece (that side that faces the jig
saw's footplate), such as when cutting an
already-installed countertop from the top.
When using reverse-tooth blades,
downward force must be applied to the
jig saw.
•
Blades with teeth that point straight out
(rather than up or down) allow splinter-
free cutting on both sides of the
workpiece. When using such blades,
downward force must be applied to the
jig saw.
•
The following types of blades should only
be used with orbital Setting O:
1.
Blades with teeth that point
downward (reverse-tooth blades).
2.
Blades with teeth that point straight
out rather than up or down.
3.
Carbide-tipped blades.
4.
Grit-edge blades.
-14-
Operating Instructions
