Bosch ICP-MAP5000-2, Руководство по установке

Страница: 46 / 90

46 en | Connections MAP 5000
2019-09 | 25 | F.01U.168.332 Installation manual Bosch Security Systems B.V.
External BDB connector (1)
4
Use this connection to connect additional system modules to the external BDB (refer to
Connecting the data bus, page 41 and Modules on the BDB, page 43).
Programmable voltage outputs (2)
4
Use these connections to control devices in certain system states (refer to Programmable
output signals, page 60).
Programmable dry relay outputs (3)
4
Use these connections to control devices such as self-powered signaling devices in
certain system states (Programmable output signals, page 60).
Voltage output AUX (4)
4
Use this connection to supply voltage to devices in the panel. The voltage can be
switched on/off in certain system states.
Supervised inputs (5)
4
Use these inputs to connect supervised conventional detectors or key switches RE = 12.1
KOhm (refer to Point types and point evaluation, page 59).
Input for panel tamper switch (6)
4
Use this input to connect the tamper switch of the panel (refer to Connecting the ICP-
MAP0050 tamper switch, page 53).
3.4 Connecting the power supply
1. Connect the AC terminal block to the power supply.
2. Connect the power supply to the main panel using the supplied four-pin connector cable
(P/N: F01U074769).
Connecting the power supply
1 1
2 2
Connection Description