Trouble shooting
en
21
Fitting the appliance door
1.
Grip the oven door on either side with both hands.
2.
Slide the hinges into the slots in the oven
(a).
Note:
The notch below the hinges must engage into
the frame of the oven
(b)
.
3.
Lower the door downwards.
4.
Remove the locking pins.
:
Warning – Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call after-sales
service.
:
Warning – Risk of injury!
The door may not close properly if the door hinges have
not engaged correctly. This will allow heat to escape
and the parts of the appliance may become very hot. To
prevent this from happening, remove the door again.
Then refit the door as shown in the drawing, making
sure that the groove on the underside of the hinges
engages in the oven frame.
3
Trouble shooting
Trouble s
hooting
Faults often have simple explanations. Refer to the table
before calling the after-sales service, as you may be
able to remedy the fault yourself.
:
Warning
Risk of injury!
Incorrect repairs may cause serious hazards. Repairs to the appliance must only be carried out by a qualified
technician. If repairs are required, contact the after-sales service.
Fault table
E
D
Fault
Possible cause
Remedy/information
The appliance is not working.
The circuit breaker is faulty
Look in the fuse box and check that the circuit
breaker is in working order.
Power cut
Check whether the kitchen light works.
Zeros are flashing in the display.
Power cut
Reset the time.
The oven light has failed.
Faulty oven light
Change the oven light bulb. (See section "Replacing
the oven light")
The gas burner will not ignite.
Power cut or damp ignition plugs
Light the gas burner with a gas lighter or a match.
Do not operate the oven without power.
The flame (oven) does not burn through all
outlet openings.
Normal build-up of dirt
The burner must be cleaned by a professional.
All dishes that are cooked in the oven burn
within an extremely short period of time.
Faulty thermostat
Call the after-sales service.
The door panel steams up when the oven is
hot.
Normal occurrence; caused by the difference in
temperature
Not possible; this has no effect on oven perfor-
mance.
The oven switches off.
The gas pressure is too high
Check whether the correct pressure regulator is
being used.
Power cut
Check the oven's power supply.