Bosch HSE420123, Инструкция по эксплуатации

Страница: 11 / 24

11
Care and cleaning
With attentive care and cleaning, your hob and oven will retain
its looks and remain in good working order for a long time. We
will explain here how you should care for and clean them
correctly.
Notes
■
Slight differences in the colours on the front of the oven are
caused by the use of different materials, such as glass,
plastic and metal.
■
Shadows on the door panel which look like streaks, are
caused by reflections made by the oven light.
■
Enamel is baked on at very high temperatures. This can
cause some slight colour variations. This is normal and does
not affect operation. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
Cleaning agents
Damage to the various different surfaces caused by using the
wrong cleaning agent can be avoided by observing the
following instructions.
Do not use
for the hob
■
undiluted washing-up liquid or dishwasher detergent
■
abrasive materials, scouring sponges
■
aggressive cleaners such as oven spray or stain removers
■
high-pressure cleaners or steam jet cleaners
Do not use
for the oven
■
harsh or abrasive cleaning agents
■
cleaning agents with high concentrations of alcohol
■
hard scouring pads and sponges
■
high-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must have
cooled down.
Detaching the rails
1.
Lift up the front of the rail
2.
and unhook it (figure A).
3.
Then pull the whole rail forward
4.
and remove it (Fig. B).
Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
1.
First insert the rail into the rear socket, press it to the back
slightly (figure A),
2.
and then hook it into the front socket (figure B).
The rails fit both the left and right sides. Ensure that, as shown
in figure B, levels 1 and 2 are below and levels 3, 4 and 5 are
above.
Enamel surfaces and
lacquered surfaces
Clean with some washing-up liquid and a damp cloth. Dry with a soft cloth.
Electric hotplate
Clean with the hard side of a scouring sponge and some liquid scouring agent. After cleaning, switch the
hob on briefly to dry it. Wet hobs rust over time. Then apply a care product. Always remove spilt liquids and
food residues immediately.
Metal ring of the
electric hotplate
The metal ring may discolour over time. However, it is possible restore the original colour. Clean the ring
with the hard side of a scouring sponge and some liquid scouring agent. When doing so, make sure that
you do not scour the adjacent surfaces, as this could damage them.
Knobs Clean with some washing-up liquid and a damp cloth. Dry with a soft cloth.
Door glass
Can be cleaned with glass cleaner. Do not use any harsh cleaning agents or sharp metal objects. These
could scratch and damage the surface of the glass panel.
Seal
Clean with some washing-up liquid and a damp cloth. Dry with a soft cloth.
Inside the oven
Clean with hot water or vinegar solution. For heavy soiling: Only use oven cleaner on cold surfaces.
Glass cover on the
oven light
Clean with some washing-up liquid and a damp cloth. Dry with a soft cloth.
Childproof lock
(option)
If a childproof lock has been fitted on the oven door, it must be removed before cleaning. Soak all plastic
parts in hot soapy water and wash with a sponge. Dry with a soft cloth. If very dirty, the childproof lock will
not work properly.
Plinth drawer
Clean with some washing-up liquid and a damp cloth. Dry with a soft cloth.
Accessories Soak in hot soapy water. Clean with a brush or sponge.
% $
% $