en
Basic settings
16
13 Basic settings
You can configure the basic settings for your appliance to meet your needs.
13.1 Overview of the basic settings
Display
Setting
Value
Childproof lock
- Manual.
1
Automatic.
– Switched off.
Audible signals
– Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
1
.
Automatic switch-off of the cooking zones.
– switched off.
1
- - minutes until the appliance switches off auto-
matically.
Duration of the timer end signal tone
– 10 seconds
1
– 30 seconds
- 1 minute
Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob. You can find precise information on the
rating plate. If the function is active and the
hob has reached the set power limit, is dis-
played and you cannot select a higher power
level.
- Switched off. Maximum power of the hob
1
.
- 1000 W. Lowest power setting.
. - 1500 W.
...
- 3000 W. Recommended for 13 A.
. - 3500 W. Recommended for 16 A.
- 4000 W.
. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
Time for selecting the cooking zone
- Unlimited: You can adjust the last selected cooking
zone without having to select it again.
1
– Limited: You can adjust the last selected cooking
zone within 10 seconds after selecting it. After this time,
you must select the cooking zone again before adjusting
it.
Cookware test
You can use this function to test the quality
of the cookware.
- Not suitable.
- Not optimal.
- Suitable.
Automatic management with power limitation
- Deactivated: Does not show the power limit unless
is activated.
1
- Switched on: Always displays the power limit.
Restoring factory settings
- Individual settings
1
.
- Factory settings.
1
Factory setting
13.2 To go to the basic settings
Requirement:
The hob must be switched off.
1.
To switch on the hob, touch .
2.
Within the next 10 seconds, press and hold
for
four seconds.
Product information
Display
Directory for the technical after-sales
service (TK)
Production number
Product information
Display
Production number 1
.
Production number 2
.
a
The first four displays provide the product informa-
tion. Touch or to view the individual displays.
3.
Touch
to access the basic settings.
a
and light up alternately as well as as a preset
value.
4.
Touch
repeatedly until the desired setting ap-
pears.
5.
Use or to select the required value.
6.
Touch and hold
for four seconds.
a
The settings are saved.
Содержание HLR390020
Страница 43: ......
