20
Removing and refitting the door panels
The glass panels can be removed from the oven door to allow
more thorough cleaning.
Removal
1.
Removing the oven door See the section
Removing the oven
door
. Lay the oven door on a cloth with the handle facing
downwards.
2.
Remove the cover from the top of the oven door. To do this,
press with your fingers on the left and right-hand side. Pull
out the cover (Fig. A).
3.
Raise the top panel and pull it out (Fig. B).
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting
1.
Hold the top glass panel firmly by the sides and slide it in
towards the back at an angle. The panel must be inserted
into the openings on the lower side. The smooth surface must
face outwards, while the roughened side must be on the
inside. (Fig. A).
2.
Place the cover on the top of the oven door and press in
place. Make sure that the grooves along the sides lock into
position.
3.
Refitting the oven door See the section
Refitting the oven
door
.
Do not use the oven again until the panels have been
correctly fitted.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section
Tested for you in our cooking studio
, where you will
find plenty of cooking tips and tricks.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
1.
Place a tea towel in the oven when it is cold to prevent
damage.
2.
Unscrew the glass cover by turning it anti-clockwise.
3.
Replace the bulb with one of the same type.
4.
Screw the glass cover back in.
5.
Remove the tea towel and switch on the circuit breaker.
Glass cover
You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
%
$
$
Problem
Possible cause Remedy/information
The oven does
not work.
The circuit
breaker is
defective.
Look in the fuse box and
check that the circuit
breaker is in working order.
Power cut
Check whether the kitchen
light or other kitchen appli-
ances are working.
The clock dis-
play flashes.
Power cut
Reset the clock.
The oven does
not heat up.
There is dust on
the contacts.
Turn the control knobs back
and forth several times.
The gas burner
does not ignite.
Power failure or
damp ignition
plugs.
Light the gas burner with a
gas lighter or a match.
Содержание HGV74X456T
Страница 1: ... en Instruction manual Free standing cooker HGV74X456T ...
Страница 2: ......
Страница 31: ......