10
Checking the oven burner nozzle (option)
1.
Open the gas supply.
2.
Carefully close the hole in the oven burner nozzle using your
finger or a suitable device.
3.
Spray the nozzle with a leakage spray.
4.
Press the function selector and turn it anti-clockwise. This
supplies the nozzle with gas.
If small bubbles or foam form, indicating a gas leak, follow the
instructions in the section entitled
"In the event of a gas leak"
.
Check the grill burner nozzle (option)
1.
Open the gas supply.
2.
Carefully close the hole in the grill burner nozzle using your
finger or a suitable device.
3.
Spray the nozzle with a leakage spray.
4.
Turn the oven function selector clockwise. This supplies the
nozzle with gas.
If small bubbles or foam form, indicating a gas leak, follow the
instructions in the section entitled
"In the event of a gas leak"
.
Correct flame formation
Burners
The burning and soot formation of each burner must be
checked after the product has been converted to a different
gas type.
If there is a problem, compare the nozzle values with the values
in the table.
1.
Ignite the gas burners in accordance with the instructions in
the operating manual.
2.
Set the burner head to a small flame.
Check whether the flame safety system is working by keeping
the flame at the "small flame" setting for one minute.
3.
Check that the burners are burning correctly with both large
and small flames. The flame should burn evenly and steadily.
4.
Turn the burner knob back and forth quickly between the
large flame setting and the small flame setting. Repeat this
process several times. The gas flame must not flicker or go
out.
Oven
Bottom gas burner or gas grill burner (optional)
1.
Ignite the lower gas burner in accordance with the
instructions in the operating manual.
2.
Open the oven door and observe the flame.:
The flame must burn evenly. (Failure may occur during the
first few minutes. However, the flame must stabilise after a
few minutes.)
3.
Switch on the appliance for a few minutes to check whether
the thermocouple becomes sufficiently warm.
If required, check the settings and, in the event of a fault,
ensure that the setting for the bypass nozzle on the burner is
correct.