Installation and connection
en
11
Setting up the appliance
■
The appliance must be set up directly on the kitchen
floor and in line with the specified dimensions. The
appliance must not be set up on any other object.
■
The distance between the top edge of the oven and
the bottom edge of the extractor hood must meet the
requirements of the extractor hood manufacturer.
■
Ensure that the appliance is not moved again after
set up. The distance from the high output burner or
wok burner to the fronts of the adjacent units or the
wall must be at least 50 mm.
:
Warning – Risk of gas leak!
The appliance must not be moved once it has been
installed.
If you do move the appliance once it has been installed,
check that the connection is leak-tight.
Measures to be noted during transport
Secure all mobile parts in and on the appliance using
an adhesive tape that can be removed without leaving
any traces. Push all accessories (e.g. baking tray) into
the corresponding slots with cardboard at the edges, in
order to avoid damaging the appliance. Place
cardboard or similar between the front and rear side to
prevent knocks against the inside of the glass door.
Secure the door and, if available, the top cover to the
appliance sides using adhesive tape.
Keep the original appliance packaging. Only transport
the appliance in the original packaging. Observe the
transport arrows on the packaging.
If the original packaging is no longer available
pack the appliance in protective packaging to
guarantee sufficient protection against any transport
damage.
Transport the appliance in an upright position. Do not
hold the appliance by the door handle or the
connections on the rear, as these could be damaged.
Do not place any heavy objects on the appliance.
0LQ
