Bosch HBC86P7 3 Series, Инструкция по эксплуатации

Страница: 19 / 40

19
7.
Push the door downwards again and tighten the screws
hand-tight using a flat-bladed screwdriver (blade width 8-
11 mm), close the door. (Fig. G).
Note: The oven may only be used again when the panels are
correctly installed.
Malfunction table
Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Malfunction table
Error messages with E
If an error message with E is shown in the display, press the 0
button. Then reset the clock. This cancels the error message. If
the error is shown again, call the after-sales service. With error
messages E101, E104 and E106, you can still operate the
microwave.
If error message E011 is displayed, a button may have become
stuck. Press each button individually and check that they are all
) *
Problem Possible cause Remedy/information
The appliance does not work. Faulty circuit breaker Look in the fuse box and check that the circuit
breaker is in working order.
Plug not plugged in Plug it in
Power cut Check whether the kitchen light works.
“Set clock” appears in the display. The
clock is not showing the current time.
Power cut Turn the rotary selector to set the current time
then press the
0
button.
The oven door cannot be opened. The
text “Set clock” appears in the display.
The clock is not showing the current
time.
Power cut during self-cleaning operation Turn the rotary selector to set the correct time
then press the
0
button. Wait until the
cooking compartment has cooled down. The
L symbol goes out. You can now open the
oven door.
The oven does not heat up. The text
“Demo” appears in the status bar.
The oven is in demo mode Switch off the circuit breaker in the fuse box
and then switch back on after approx. 20
seconds. Within the next 2 minutes hold the
D
button down for 4 seconds until "Demo"
disappears.
"Automatic switch-off" appears in the
display.
Automatic switch-off has been activated.
The oven stops heating.
Press any button. The text goes out. You can
make settings again.
The microwave does not switch on. Door not fully closed. Check whether food remains or foreign
material is trapped in the door. Make sure that
the sealing surfaces are clean. Check whether
the door seal is twisted.
The microwave was not started.
Press the n button.
The appliance does not heat up to the
temperature which has been set.
The
n
button was not pressed. Press the
n
button.
Microwave operation has been
cancelled for no apparent reason.
The microwave has a fault. If this fault occurs repeatedly, please call the
after-sales service. Oven operation without
microwave is possible.
With microwave operation, the food
takes longer to heat up than before.
The microwave power setting is too low. Select a higher power setting.
A larger amount than usual has been
placed in the appliance.
Double the amount = almost double the time
The food was colder than usual. Stir or turn the food during cooking